Texas Industrial Remcor, Inc. Help Center
Home
Shop Categories
Catalogs
Find A Dealer
About
Contact
Help Center
Solenoid Valve Troubleshooting
Is the solenoid good?
Categories
Pressure Regulator Troubleshooting
Solenoid Valve Troubleshooting
Freezing and splitting
Can I buy parts or the just the whole valve - which is better?
I turn the system on and the fuse blows immediately
How to plug in spade system - wiring
What color wire goes to which boom?
System starts spraying correctly and then just tapers off and shuts down, but solenoids are open
What should I put in the valves to avoid freezing?
My valves were working last fall when I put the sprayer up
What is an E-Chip?
Solenoid turns on-off as I drive
Solenoid partially opens
Is the solenoid good?
Motorized Valve Troubleshooting
Control Systems Troubleshooting
Manual Valve Troubleshooting
Plumbing the System
Menu
Is the solenoid good?
Check the resistance - should be about 6 for the 2.0A solenoids and 11 for the 1.1 solenoids. The other way to test is to use jumper sires and energize from a battery holding the plunger in the tube to determine if the solenoid will draw it in.
Rate this article
For more questions -
Contact Us
Categories
Pressure Regulator Troubleshooting
Solenoid Valve Troubleshooting
Freezing and splitting
Can I buy parts or the just the whole valve - which is better?
I turn the system on and the fuse blows immediately
How to plug in spade system - wiring
What color wire goes to which boom?
System starts spraying correctly and then just tapers off and shuts down, but solenoids are open
What should I put in the valves to avoid freezing?
My valves were working last fall when I put the sprayer up
What is an E-Chip?
Solenoid turns on-off as I drive
Solenoid partially opens
Is the solenoid good?
Motorized Valve Troubleshooting
Control Systems Troubleshooting
Manual Valve Troubleshooting
Plumbing the System
...
